Early access
posted nov 21, 2026

Center of Gravity

2 0
about this buildShikaka

Center of gravity – 1/24 crawler (with battery mounted)

Method: I hung the car from a string, once from the front and once from the rear, and photographed it each time. In each photo I extended the string straight down through the car. Where the two lines cross is the center of gravity, and they crossed at about 70°, which is a good angle for an accurate result. The wheel hub centers served as reference points to line up the two photos.

Reference dimensions

  • Wheelbase 126.55 mm

  • Tire diameter: 71 mm, so the radius is 35.5 mm

Result

  • Longitudinal: about 52 mm behind the axle on the battery end and about 75 mm from the other axle. That’s a weight distribution of about 59 : 41, biased toward the battery end.

  • Height above the axle centerline: about 13 mm

  • Height above the ground: 35.5 + 13 ≈ 48 mm with the suspension fully drooped (hanging). On the ground, with the suspension settled, it’s probably about 45 mm.

  • Accuracy: roughly ±3 mm

For a 1/24 crawler on 71 mm tires, that’s a nicely low center of gravity.

Comments (0)

Log in to comment.

No comments yet.